Nortel 252 Configuration page 285

Table 68 IPSec commands
Command
load <rule index>
save
config
name
active
negotiationMode
natTraversal
p1MultiPro
lcIdType
lcIdContent
myIpAddr
peerIdType
peerIdContent
secureGwAddr
authMethod
certificate
preShareKey
p1EncryAlgo
p1AuthAlgo
p1SaLifeTime
keyGroup
<name>
<Yes|No>
<0:Main |
1:Aggressive>
<Yes|No>
<Yes|No>
<0:IP | 1:DNS |
2:Email>
<content>
<IP address>
<0:IP | 1:DNS |
2:Email>
<content>
<IP address |
Domain name>
<0:PreSharedKey
|1:
RSASignature>
<certificate
name>
<ASCII | 0xHEX>
<0:DES | 1:3DES
| 2:AES>
<0:MD5 |
1:SHA1>
<seconds>
<0:DH1 | 1:DH2>
Nortel Business Secure Router 252 Configuration — Advanced
Appendix G Command Interpreter 285
Description
Edit an IPSec branch office rule with the
specified rule number.
Saves the IPSec branch office rule.
Uses these commands to configure the
IPSec rule.
Sets the name of the rule.
Turns the rule on or off.
Sets the negotiation mode.
Turns NAT traversal on or off.
Turns phase 1 multiple proposal on or off.
Sets the local ID type.
Sets the local ID content.
Sets the My IP Address.
Sets the peer ID type.
Sets the peer ID content.
Sets the secure gateway address.
Sets the authentication method.
Specifies the certificate to use for
authentication.
Types 8 to 32 case-sensitive ASCII
characters or 16 to 62 hexadecimal (0-9,
A-F) characters (preceded by 0x (zero x),
which is not counted as part of the 16 to
62 characters).
Sets the phase 1 encryption algorithm.
Sets the phase 1 authentication
algorithm.
Sets the phase 1 SA lifetime.
Sets the key group for phase 1 IKE setup.