Wan Commands; Table 69 Wan Commands - Nortel 252 Configuration

292 Appendix G Command Interpreter
Table 68 IPSec commands
Command

WAN Commands

The following chart lists and describes the wan commands. Each of these
commands must be preceded by wan when you use them.

Table 69 WAN Commands

Command
wan
adsl
NN47923-501
anpr <on | off>
age <days>
minLen
bert
cellcnt
chandata
close
defbitmap
dyinggasp
linedata far
near
open
opencmd
opmode
perfdata
Description
Enables or disables the requirement of a
alpha-numeric password.
Sets the maximum password age after
which the login password expires, valid
value: 0~180 days, and 0 means no
expiration.
Sets the minimum password length.
Description
Displays ADSL ber.
Displays the ADSL cell counter.
Displays the ADSL operational mode
(standard) and ADSL channel data, line rate.
Closes the ADSL line.
Displays ADSL defect bitmap status.
Sends ADSL dyinggasp.
Shows ADSL far end noise margin and carrier
load information.
Shows ADSL near end noise margin and
carrier load information.
Opens the ADSL line.
Opens ADSL line with a specific standard.
Shows the ADSL operational mode
(standard).
Shows performance information such as the
CRC,FEC, error seconds.