Ipsec Commands; Table 68 Ipsec Commands - Nortel 252 Configuration

Table 67 IP commands
Command
enable
disable

IPSec commands

Table 68
be preceded by
IPSec rule, if you have it configured.

Table 68 IPSec commands

Command
debug type
level
display
switch <on|off>
timer
<ALG_FTP|ALG_H323
|ALG_SIP>
<ALG_FTP|ALG_H323
|ALG_SIP>
lists and describes the IP Sec commands. Each of these commands must
. For example, type
ipsec
<0:Disable |
1:Original
on|off | 2:IKE
on|off | 3:
IPSec
[SPI]|on|off |
4:XAUTHon|off |
5:CERT on|off |
6: All>
<0:None |
1:User | 2:Low
| 3:High>
Nortel Business Secure Router 252 Configuration — Advanced
Appendix G Command Interpreter 283
Description
Turns on the ALG.
Turns off the ALG.
ipsec display 3
Description
Turns the trace for IPsec debug
information on or off.
Sets the debug level. The higher the
number, the more detailed.
Shows debugging information, including
type and level.
As long as there is one active IPSec rule,
all packets go into the IPSec process to
check against the SPD. When this switch
is turned on, packets are not be put
through the IPSec process, even if there
are active IPSec rules.
to display the third