Barco F70 Series User Manual page 72

Physical Installation
1
Image 4–10
3. Adjust the right side Scheimpflug adjustment screw (reference 2 in the next figure) until the test image in
the top right side of the screen is in focus. Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally
normal.
2
Image 4–11
4. Adjust the top Scheimpflug adjustment screw (reference 3 in the next figure) until the test image in the
bottom half of the screen is in focus. Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally
normal.
3
Image 4–12
5. Continue adjusting the screws one at a time until the test image is uniformly sharp across all areas of the
display.
6. Test the focus by zooming in and out, and verify that the image stays sharp during the complete zoom
range. If there are any deviations to sharpness, repeat steps 2 to 6 until the image is correct.
7. Tighten the three set screws in the following order: left (1b), right (2b) and then top (3b). Use a size 6 hex
key to do this.
72 601–426 /15 F70 Series
F
F
F