Installation Process; Installation Conditions - Barco F70 Series User Manual

Physical Installation

4.1 Installation process

Installation process

1. Ensure that the installation area meets all the environmental requirements. See
page 62.
2. Decide the mounting configuration. See
3. Unpack the projector, and confirm that the equipment are present, and in good working order. See
inspection", page
4. Mount the projector in the decided orientation. See
attachment points", page
5. Install the lens. See
lens (0.38:1) UST", page 51
6. Connect the source. See
7. Power up the projector.
8. Adjust and set up the projector. See
Do not hesitate to refer to the user manual to obtain more information concerning the user interface
and supplementary information.

4.2 Installation conditions

Environmental Conditions
Barco projectors are manufactured according to specific design standards, which also include
environmental conditions. Failing to follow the terms and conditions outlined in this chapter can
result in loss of product warranty
The table below summarize the physical environments in which the projector may be safely operated or
stored.
Environment
0 -500m
500 -1500m
1500 - 3000m
Maximum Air Flow
For PRC (People's Republic of China).the certified altitude is specified on the product label.
Mains power requirement
Projector
F70
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
62 601–426 /15 F70 Series
"Positioning the projector", page
63.
66.
"Replace a lens", page 45. In case of installing an UST lens, see
and "Mounting the FLDX lens (0.38:1) UST lens with a lens support", page
"Getting started", page
See"Power up the projector", page
"Getting started", page
Ambient operating
temperature
+10 to +45 °C
+10 to +40 °C
+10 to +35°C
471m 3 /hour
64.
"Positioning the projector", page 64
73.
77.
73.
Relative Humidity
10 –80% RH
10 –80% RH
10 –80% RH
10 –80% RH
Power Requirement
100 –240V. 50 –60 Hz.

"Installation conditions",

"Initial
and "Projector safe
"Preparing the FLDX
55.
Storage condition
–20 to +60 °C, 10 – 90 %
RH
–20 to +60 °C, 10 – 90 %
RH
–20 to +60 °C, 10 – 90 %
RH
Not Applicable