Parameter
Max. input data resolution
Bit depth
EDID
HDCP
5.1.2.3 Specifications HDMI 2.0
Specifications
Regarding HDMI 2.0: The decryption protocol HDCP 2.2 are enabled and valid in this unit.
Parameter
Connector
Signal characteristics
Max. cable length
Max. pixel rate
Max. input data resolution
Bit depth
EDID
HDCP
Ethernet
Audio return
HDCP
5.1.2.4 Specifications SDI inputs
Specifications
Parameter
12G-SDI
Standard
SMPTE ST-2082-1 and ST-2082-10
standards
Connector
Samtec BNC7T-J-P-HN-RA-BH1
Bandwidth
12GHz
Return loss
-6dB @ 12GHz
Impedance
75 ohm resistive
5.1.2.5 Specifications HDBase T input
The HDBaseT standard allows the link to also be used as a regular network port. In addition to
carrying video data, it can also be connected to regular ethernet network without carry out any video
data.
Due to limitations in the projector and network standards, only the LAN and the HDBaseT should be
used for network traffic, but not both simultaneously. If both are connected simultaneously it might
lead to undefined behavior where traffic is not being sent on the link indicated by the IPaddress.
This is only valid when the projector has a firmware version 2.1 or higher installed.
Value
2560x1600@120Hz WQXGA / 3840x2400 @60Hz
(4K ) Max
8, 10, 12 bit
Supported
Supported
Value
Standard HDMI
Digital, TMDS
2 m (24 AWG)
594 MHz
3840x2160 @60Hz
8, 10, 12 bits
Supported
Supported
No
No
Supported
3G-SDI
SMPTE 424M-2006 10bit level A
1x) BNC 75 ohm type IEC 60169-8,
Amendment 2 1997, A
>3 GHz
>10dB at 3GHz
75 ohm resistive
601–426 /15
Getting started
F70 Series
75