Platinum Remote Control Unit; Remote Control, Battery Installation - Barco F70 Series User Manual

Getting to know the projector.
CAUTION: Replace batteries with the correct battery type. Only use AAA size batteries. There is a
risk of explosion if the battery is replaced with an incorrect type.
Make sure the polarities match the + and - marks, as depicted on the inside of the battery
compartment. There is a risk of explosion if the batteries are installed incorrectly.
Functions
Image
1
2
3
4
5
6
7

2.9 Platinum remote control unit

2.9.1 Remote control, battery installation

Where to find the batteries for the remote control ?
The batteries are not placed in the remote control unit to avoid control operation in its package, resulting in a
shorter battery life time. At delivery the batteries can be found in a separated bag attached to the remote
control unit. Before using your remote control, install the batteries first.
How to install
1. Push the battery cover tab with the fingernail a little backwards (1) and pull, at the same time, the cover
upwards (2).
32 601–426 /15 F70 Series
Nr
1
2
8
3
9
4
10
5
6
7
11
8
12
9
10
11
12
Description
Close shutter
Open shutter
Button pressed indicator
Open Lens menu
Menu navigation keys
Move back one level in menu system
Open Source menu
Power on / Power off
Note: Only shifts power between Ready and ON
mode.
OSD menu on / off
Menu confirmation
Activate or deactivate the GUI menu.
Note: If pressed while the projector is in stand-by
mode, this will also power up the projector.
Open Test pattern menu