Lan/Ethernet; Usb-A Port; Power Up The Projector - Barco F70 Series User Manual

5.1.3.2 LAN/Ethernet

Specifications
Parameter
Ethernet connector
Protocols
Speed

5.1.3.3 USB-A port

Specifications
Parameter
USB connector
Function
Power
Standard
5.1.3.4 DMX
DMX interface
DMX is used as communication bus between different devices in the light technic. Each device has an input
and an output, so that the bus can be looped between the different devices. According the standard a five wire
cable with XLR connector is used.
You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can
control the projector from that DMX device (console). The DMX output port can be connected with the next
device in the loop.
Description
Pin
1 Earth
2 Cold
3 Hot
4 Return - (or not used)
5 Return + (or not used)
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a
lighting controller to lighting devices. Standardized by USITT.

5.2 Power up the projector

CAUTION: Sources should always be connected before the projector is powered up
CAUTION: Ensure that the main power cord complies with the national regulations where the
equipment is used.
Do not use unauthorized replacements.
Do not use power cords which are damaged.
Value
1 RJ45 Connector for projector control (not content)
DHCP, TCP/IP, UDP/P
10/100 Mbit/1000Mbit
Value
Type A
Firmware upgrade using USB sticks
Power 5V, max 1,5A (out)
USB 2.0
601–426 /15
Getting started
F70 Series 77