Backlight; Eco Mode - Barco F70 Series User Manual
Hide thumbs
Also See for F70 Series:
- Service manual (168 pages) ,
- User manual (136 pages) ,
- Installation manual (22 pages)
Table of Contents
Advertisement
Image 10–14 Select temperature unit
10.9 Backlight
About backlight settings
Enter the menu Settings / User interface / Backlight
The backlight menu shows up.
Image 10–15
Setting the backlight modes
•
Stealth mode : With this enabled, the backlight on the LCD and the buttons will be always off. The
indication LED's for the HDbaseT and LAN will also be disabled.
When "On until Reboot" is enabled, the backlight on the LCD will be on during reboot, and en power
transition cycle (on/ready state to eco mode, and back again).
•
Backlight: Select the time delay for turning off the LCD backlight. There are several predefined values,
and also possible to set a custom value.
10.10 ECO mode
About Standby ECO
When the ECO mode is enabled, the projector will automatically go to ECO standby mode after a time-out
(default 15 minutes). All electronics (including fans, pumps, ...) go down except for a very small wake-up
controller. See section dedicated to the Power Mode transitions for further details.
System settings menu
601–426 /15
F70 Series
155
Advertisement
Table of Contents
