Lan/Ethernet; Power Up The Projector; Power Down The Projector - Barco F70 Series User Manual

5.1.3.2 LAN/Ethernet

Specifications
Parameter
Ethernet connector
Protocols
Speed
5.1.3.3 USB-A port
Specifications
Parameter
USB connector
Function
Power
Standard

5.2 Power up the projector

CAUTION: Sources should always be connected before the projector is powered up
CAUTION: Use only power cords following the unit, designed for your projector model. Do not use
unauthorized replacements. Do not use power cords which are damaged.
Power up the projector using the keypad or remote
1. Connect the line cord to the projector.
2. Plug the 3–pronged cord into a grounded AC outlet.
The projector will begin warming up, and the backlight of the Standby /power button are flashing white.
3. When the backlight on the standby button are constant white, the projector are in standby mode, ready to be
switched on.
4. Press the standby button on the keypad or the power button on the remote to bring the projector up to on
mode.
The power button backlight on the keypad will flash blue while the projector is warming up.
5. When the power button backlight is steady blue, the projector is ready for use.

5.3 Power down the projector

Power down using the keypad or remote
1. Depress and hold the power button on the keypad or remote for four (4) seconds.
The Projector is now in cooling down phase.
2. Wait 2 minutes before disconnecting the power cord. (If disconnecting is required).
Value
1 RJ45 Connector for projector control (not content)
DHCP, TCP/IP, UDP/P
10/100 Mbit/1000Mbit
Value
Type A
Firmware upgrade using USB sticks
Power 5V, max 1,5A (out)
USB 2.0
Getting started
601–426-03 F70 Series 63