Advertisement
Power down the projector
1.
Press and hold the power button for 3 seconds. (A timer indicator will show up on the display).
2.
The power button illumination will become white, and projector will enter the cool down modus for
approximately 5 minutes.
3.
When the backlight for the keypad is off, unplug the power cord from the projector.
3 sec
Connect and select source
1.
Connect available sources to the appropriate input ports.
2.
Select connected source.
(See User Guide for detailed menu navigation steps).
Input LEDs explained:
•
Select LED (reference 1)
-
GREEN : port configured as input. Image appears on the screen.
-
Blinking GREEN : bidirectional port configured as output/loopthrough.
Sync LED (reference 2)
•
-
YELLOW : sync/signal is present.
Adjust
1.
Adjust the lens settings by pressing the lens menu button on the keypad or via the zoom, shift and focus
buttons on the keypad.
2.
Orientation of the unit is set as standard in table front projection mode.
Change the projector set up in the INSTALLATION > ORIENTATION menu.
3.
For Advanced adjustments like Warping, Light management, etc. see projector User Guide.
5 min
- 4 -
Select
1
Sync
2
Advertisement
