Connector Panel - Barco F70 Series User Manual

Getting to know the projector.
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: "System Settings" → "Communication" →"IR
Control ".
Placing new batteries in the remote control or plugging the remote to a projector via a cable will
automatically reset the address back to its default value '0'.

2.11 Connector panel

General
The source input panel is located at the back of the projector. For source specifications, see table below.
Image 2–1
Name Pcs
DMX IN 1
DMX OUT 1
RS-232 1
Sync 3
Trigger 3 (one in
front,
two on
rear
panel)
RC 1
USB 3
LAN 1
DP 2
DL-DVI-D 2
HDMI 1
HDBaseT 1
SDI 2
38 601–426 /15 F70 Series
Description
DMX 512 input
DMX 512 output
9–pin DB9 connector
BNC Sync Port IN/OUT;
Bidirectional mini-DIN (1x 3D
sync Out, and 2x Sync In/Out)
12VDC - 0,5A (6W)
Trigger Out Voltage
No Connection
Ground
Jack connector for wired
remote
USB 2.0 type A, 4 pin( 2x Rear
and 1x Front)
Standard RJ45 connector
Standard display port
Dual DVI-I 1.0 (DVI_D
Functionallity).
Standard HDMI 2.0
Standard RJ45 8P8C
Connector
SDI1 is Input, SDI 2 is pass
through. (out)
Purpose
For Projector Control
For Projector Control
For Projector Control. Allows for wired remote
control and monitoring of many projector functions
used in installation environments
For Projector ControlThis is mainly used in multiple
projector installations with requirement of
synchronization between the units
For Controlling Peripherals, like motorized
screens, curtains etc. Give 12V output when
activated. See API manual for activation info.
NOTE Disconnect the projector power cable
before connecting or removing the trigger
cable.
For Projector Control
For Software upgrade
For Projector Control
For Projector Input
For Projector Input. These connectors can also be
used to form one uniform image by feeding half of
the image into each connector. HDCP compliant
for sources up 165 Mhz
For Projector Input
For Projector Control
For Projector Input