Using Dual Inputs - Barco F70 Series User Manual
Hide thumbs
Also See for F70 Series:
- Service manual (168 pages) ,
- User manual (136 pages) ,
- Installation manual (22 pages)
Table of Contents
Advertisement
Source menu
Image 6–6
The Connector Settings menu for this connector will be displayed.
Image 6–7 Example of connector settings of an Displayport Connector.
5.
You can change the following:
•
To force a limit on the color space, select one of the available color spaces.
•
To force a limit on the used signal range, select one of the available signal ranges.
•
To set a video timing other than the one native for the connector, select one of the options under EDID.
Note: You cannot change the EDID for SDI connectors.
6.3 Using dual inputs
Dual Input.
For extended flexibility to connect high resolution sources with a pixel clock over 330 MHz, the projector is
supporting a dual input mode. In this mode, the left and the right half of the image can be connected to the
DVI-1 and DVI-2 respectively, or DP1 and DP2.
To enable this mode, select the source that fits in the Menu/Source
Dual input modes
There are four ways to connect dual input.
•
Dual Displayport Columns
•
Dual Displayport Sequential
•
Dual DVI Columns
•
Dual DVI Sequential
86
601–426 /15
F70 Series
Advertisement
Table of Contents
