Control Interface Specifications - Barco F70 Series User Manual
Hide thumbs
Also See for F70 Series:
- Service manual (168 pages) ,
- User manual (136 pages) ,
- Installation manual (22 pages)
Table of Contents
Advertisement
Getting started
Specifications
Parameter
Reference specification
Connector
Signal characteristics
Max. cable length (1080p/48b/60Hz)
Max TMDS Clock Frequency
Max video resolution supported
HDCP Pass-Through
IR Extension
RS-232 Extension
10/100Mbps Ethernet Pass-Through
Fallback to 100BaseTx, IEEE 802.3u
USB Over Centre Tap
Power Over Ethernet
Audio
LEDs - HD Base Status
5.1.3 Control interface specifications
The HDBaseT input can also be used as a regular network port. See
page
74, HDBaseT specification.
About
This section gives information about interfaces used to control the projector.
5.1.3.1 RS-232
Specifications
Parameter
RS-232 connector
76
601–426 /15
F70 Series
Value
HDBaseT 1.0 Specification, June 2010
Standard RJ-45, 8P8C
HDBaseT
100 m (Cat5e/6), Pixel Clock <=225HHz, Video
Datarate <=5.3Gbps
70 m (Cat5e/6), Pixel Clock >225HHz, Video
Datarate >5.3Gbps
100 m (Cat6a/7), Pixel Clock >225HHz, Video
Datarate >5.3Gbps
270 MHz
4096x2160 @30Hz
Yes, from Source to Projector
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Operation: Green, Left
Link/Mode: Yellow, Right
"Connector specifications",
Value
1 female DB9 connector (RS232-in) for projector
control and debug
Advertisement
Table of Contents
