Siemens SICHARGE UC 150 Operating Instructions Manual page 126

Operation
9.3 Operation via HMI
Advanced settings
Information and setting options for each charging port are shown in the area "Advanced
settings". To open the area, select the "Advanced settings" button in the Settings (Page 122).
Figure 9-13 Advanced settings
If there are several dispensers, select the one you require using the drop-down menu.
The following information is displayed:
Table 9-1 Information about the electricity supply
Section Voltage
L1-L2 Voltage between the phases in Volt
L2-L3 Voltage between the phases in Volt
Output Voltage at the output in Volt
DC link voltage Voltage in the DC link
Frequency Line frequency in Hz
Table 9-2 Information about temperature
Section Temperature
Fan control system Temperature at the fan control
IGBT Temperature at the power switch modules
126
Current
Current between the phases in Ampere
Current between the phases in Ampere
Current at the output in Ampere
Speed
Fan speed in % of the maximum speed
To change the maximum fan speed, press the
text box and enter a value using the numeric
keypad.
Operating Instructions, 02/2023, A5E50068475-AB
SICHARGE UC 150