Siemens SICHARGE UC 150 Operating Instructions Manual page 131

Alarm message
highOutputCurrent
ressTemperatureInhibit
evShiftPosition
chargerConnectorLockFault
evRessMalfunction
chargingCurrentDiff
chargingVoltageOutOfRange
chargingSystemIncompatibility
sessionSetupFailure
slacFailure
sendMessageError
EVSEShutdownTimeout
dispenserContactorTimeout
dcPlusTemperature
dcMinusTemperature
cpStateLost
pantographError
pantographDidNotMove
pantographTimeout
unexpectedError
cpBToCTimeout
sequenceError
messageTimeout
invalidDataReceived
unknownSession
invalidStage
pantographButtonPressed
positionSensorError
noCommunicationToACD
communicationLostACD
inputBreakerTimeout
converterTimeout
outputBreakerTimeout
noCommunicationToGreenInvert
communicationLostGreenInvert
inputBreakerFail
SICHARGE UC 150
Operating Instructions, 02/2023, A5E50068475-AB
10.1 Alarm messages in the alarm history
Description
Current value too high for this stage (IEC 61851, Annex C)
Electric vehicle fault
Electric vehicle fault
Electric vehicle fault
Electric vehicle fault
Electric vehicle fault
Electric vehicle fault
Electric vehicle fault
After setup of the TCP connection, the session could not reach
the cable check
Session could not establish a TCP connection, error at SLAC
An error has occurred when sending a message
Timeout for normal shutdown of the vehicle
Timeout of the contactors of the charging station
Connector temperature outside of the range at the DC+
Connector temperature outside the range at the DC-
Unexpected transition of CP state from C/D to A
Pantograph error (top and bottom)
Pantograph did not move
Pantograph did not reach the end position in time
Unexpected error occurred (error not defined)
Transition of CP state B to C timeout
Incorrect message sequence
Request not received in time
Invalid data received in request message
Unknown session received by vehicle
Invalid EVSECore stage when analyzing a request
Pantograph button was pressed
Loss of the position sensor signal during charging
No communication established with ACD (configurable
timeout)
Loss of communication with ACD (configurable timeout)
Timeout when closing/opening the input circuit breaker
Timeout during switching ON/OFF of the converter
Timeout when closing/opening the output circuit breaker
No communication established with GreenInvert (configurable
timeout)
Loss of communication with GreenInvert (configurable
timeout)
Unexpected state of the input circuit breaker received
Handling alarms and errors
131