Table of Contents
Advertisement
5-8
Netopia ISDN Router Reference Guide
IPX Profile Parameters
Remote IPX Network:
Path Delay:
NetBios Packet Forwarding:
Incoming Packet Filter Set...
Outgoing Packet Filter Set...
Incoming SAP Filter Set...
Outgoing SAP Filter Set...
Detach Filter Sets...
Periodic RIP Timer:
Periodic SAP Timer:
Return accepts * ESC cancels * Left/Right moves insertion point * Del
deletes.
Configure IPX requirements for a remote network connection here.
3.
Select Remote IPX Network and enter the network address of
the IPX network being called. Don't use an address already in
use by another connection profile. If this value is set to zero
and the Netopia ISDN Router is answering a call, the remote
address will be learned when the profile is active. Note that,
unlike IP, the IPX network address is never used in matching a
profile when answering a non-authenticated call. For dial on
demand to work, your Default Gateway should match one of
your IPX addresses in a defined connection profile.
4.
To change the default path delay, select Path Delay and enter a
value (in ticks).
5.
To enable NetBIOS packet forwarding, select NetBIOS Packet
Forwarding and toggle it to Yes.
6.
To attach a filter set for filtering incoming packets, select
Incoming Packet Filter Set and choose a filter set from the list.
7.
To attach a filter set for filtering outgoing packets, select
Outgoing Packet Filter Set and choose a filter set from the list.
00000000
10
Off
60
60
Advertisement
Table of Contents
