Netopia 435 Reference Manual page 25

2-10 Netopia ISDN Router Reference Guide
Small Office models
Select IP Profile Parameters. This is only available as an option
if IP Enabled is toggled to Yes.
IP Profile Parameters
Remote IP Address:
Remote IP Mask:
Address Translation Enabled:
Filter Set...
Remove Filter Set
Receive RIP:
Select Remote IP Address and enter the IP address of the
network being called. Do not use an address already in use by
another connection profile.
Note: You may leave the address zero if you do not yet know
the address of the other network. The address should either be
provided by them or you can configure the Netopia ISDN Router
to provide the address from the IP Address Serving pool (see
"WAN IP Address Serving," beginning on page
option is appropriate when the other network is an ISDN
modem or terminal adapter, or a Netopia ISDN Router using the
NAT (Network Address Translation ) feature set. See Chapter 5
in the Getting Started guide for more information on NAT.
Select Remote IP Mask and enter the IP mask used by the
remote network. You may leave this zero if you will be assigning
a host IP address to the remote network using the method
described in step 5)
Select Address Translation Enabled. This option's behavior will
be configured later in IP Setup in the Network Protocols Setup
section of Advanced Configuration. For more details, see
Chapter 4. IP Setup IP Network Address Translation (NAT, also
0.0.0.0
0.0.0.0
No
No
2-33. The latter