Table of Contents
Advertisement
10-6
Netopia ISDN Router Reference Guide
Ping Host Name:
Packets to Send:
Data Size:
Delay (seconds):
START PING
Status:
Packets Out:
Packets In:
Packets Lost:
Round Trip Time (Min/Max/Avg): 0.000 / 0.000 / 0.000 secs
Send ICMP Echo Requests to a network host
To configure and initiate a Ping test, follow these steps:
1.
Select Ping Host Name and enter the destination domain name
or IP address.
2.
Select Packets to Send to change the default setting. This is
the total number of packets to be sent during the Ping test. The
default setting is adequate in most cases, but you may change
it to any value from 1 to 4,294,967,295.
3.
Select Data Size to change the default setting. This is the size,
in bytes, of each Ping packet sent. The default setting is ade-
quate in most cases, but you may change it to any value from 0
(only header data) to 1664.
4.
Select Delay (seconds) to change the default setting. The
delay, in seconds, determines the time between Ping packets
sent. The default setting is adequate in most cases, but you
may change it to any value from 0 to 4,294,967. A delay of 0
seconds forces packets to be sent immediately one after
another.
Ping
5
56
1
0
0
0 (0%)
Advertisement
Table of Contents
