Ipx Setup - Netopia 435 Reference Manual

To go to the IPX Setup screen, select IPX Setup in the Network
Protocols Setup screen.
IPX Enabled:
Ethernet Network Address:
Ethernet Encapsulation...
Ethernet Path Delay:
Ethernet NetBios Packet Forwarding:
Ethernet Incoming SAP Filter Set...
Detach Filter Set...
Default Gateway Address:
Filters and Filter Sets...
Return/Enter goes to new screen.
1. To enable IPX routing, select IPX Enabled and toggle it to Yes.
2. Select Ethernet Network Address and enter the network
address of the IPX network connected to the Netopia ISDN
Router's Ethernet port.
Note: If the Ethernet network address is set to zero, the Router
will attempt to learn the address from any configured IPX device
on the Ethernet network or from the remote IPX network when a
call is established.
3. To change Ethernet encapsulation from the commonly used
802.3 standard, select Ethernet Encapsulation and choose a
different encapsulation method.

IPX Setup

Yes
00000150
802.3
1
Yes
<<NONE>>
00000000
IPX Setup 5-5