Netopia 435 Reference Manual page 80

Adding a static route
To add a new static route, select Add Static Route in the Static
Routes screen and go to the Add Static Route screen.
Static Route Enabled:
Destination Network IP Address:
Destination Network Subnet Mask:
Next Gateway IP Address:
Route Priority...
Advertise Route Via RIP:
ADD STATIC ROUTE NOW
Configure a new Static Route in this Screen.
To install the static route in the IP routing table, select Static
Route Enabled and toggle it to Yes. To remove the static route
from the IP routing table, select Static Route Enabled and
toggle it to No.
Be sure to read the rules on the installation of static routes in
the IP routing table. See
page 4-17.
Select Destination Network IP Address and enter the network
IP address of the destination network.
Select Destination Network Subnet Mask and enter the subnet
mask used by the destination network.
Select Next Gateway IP Address and enter the IP address for
the router that the Netopia ISDN Router will use to reach the
destination network. This router does not necessarily have to
be part of the destination network, but it must at least know
where to forward packets destined for that network.
Select Route Priority and choose High or Low. High means that
the static route takes precedence over RIP information; Low
means that the RIP information takes precedence over the
Add Static Route
CANCEL
"Rules of static route installation" on
IP Setup 4-15
Yes
0.0.0.0
0.0.0.0
0.0.0.0
High
No