Netopia 435 Reference Manual page 28

Select IPX Profile Parameters. This is only available as an
option if IPX Enabled is toggled to Yes.
Remote IPX Network:
Path Delay:
NetBios Packet Forwarding:
Incoming Packet Filter Set...
Outgoing Packet Filter Set...
Incoming SAP Filter Set...
Outgoing SAP Filter Set...
Periodic RIP Timer:
Periodic SAP Timer:
Configure IPX requirements for a remote network connection here.
Select Remote IPX Network (optional) and enter the network
address of the IPX network being called. Do not use an address
already in use by another connection profile. If this value is set
to zero and the Netopia is answering a call, the remote address
will be learned when the profile is active.
Note: Unlike IP, the IPX network address is never used in
matching a profile when answering a non-authenticated call.
Note: This value must be non-zero for the Netopia ISDN Router
to be able to initiate a demand connections through this profile.
To change the default Path Delay, select and enter a value (in
ticks; a tick is equivalent to 1/18 sec).
Configuring ISDN Connections
IPX Profile Parameters
00000000
10
Off
<<NONE>>
<<NONE>>
<<NONE>>
<<NONE>>
60
60
2-13