YASKAWA iQpump Manual Supplement page 86

Parameter Name
Parameter Addr.
Digital Operator
No. Hex
P9-50
Water Level Source
0878
Water Lvl Source
<0034>
P9-50
Suction Pressure Source
0878
Suction Pres Src
<0035>
P9-99 Network Compatibility
0875 Selection
Network Comp Sel
<0036>
Motor Rated Power
T1-02 0702
Mtr Rated Power
Motor Rated Current
T1-04 0704
Rated Current
Denotes that parameter can be changed when the drive is running.
86
Display
Defines which signal to use for Water Level Control (P8-
= 3.
0: Analog Only
1: Ana->Net, No Alrm
2: Ana->Net, Alarm
3: Network Only
Setting has no effect when P1-01
Defines which signal to use for Suction Pressure Control (P8-
P1-01 = 3.
0: Analog Only
1: Ana->Net, No Alrm
2: Ana->Net, Alarm
3: Network Only
Setting has no effect when P1-01
Determines the communication compatibility for the iQpump Memobus
Network
0: A-Version 30034
Use this mode if (ONE or MORE) iQpump Controllers on the network
have software version monitor U1-14=30034 and nameplate PRG: 0034.
1: B-Version 30035+
Use this mode if (NONE) of the iQpump Controllers on the network have
software version monitor U1-14=30034 and nameplate PRG: 0034.
Sets the motor rated power in kW.
Note: T1-02 should be left at the default value (last 3 digits of the drive
model number).
Sets the motor rated current. (Used only during an auto-tune.)
Description
) when P1-01
≠ 3
≠ 3
Auto-Tuning
YASKAWA TM.iQp.10 Technical Manual Supplement
Setting Factory
Range Setting
0 ~ 3 0
) when
0 ~ 3 0
0 ~ 1 1
0.00 ~ kVA
650.0 Dependent
kVA kVA
Dependent Dependent
Menu
Location
Programming
Programming
Programming
Auto-Tuning
Auto-Tuning