Table of Contents
Advertisement
Related Parameters for Geothermal Mode Operation
Parameter
b1-01
Frequency Reference Source
b5-01
PI Mode
H3-09
Terminal A2 Function Selection
o1-06
User Monitor Selection Mode
o1-02 <1>
User Monitor Selection After Power-Up
o1-08
Third Line User Monitor Selection
P1-01
Pump Mode
P4-31
Minimum Geothermal Temperature Input
P4-32
Maximum Geothermal Temperature Input
P4-33
Minimum Geothermal Speed
P4-34
Maximum Geothermal Speed
P4-35
Low Temperature to Run at Max. Geothermal speed
P4-36
Low Temperature to Run at Min. Geothermal speed
P4-37
High Temperature to Run at Min. Geothermal speed
P4-38
High Temperature to Run at Max. Geothermal speed
P4-39
Geothermal Temperature Loss Detection
<1> After programming is completed, cycle power to the drive, as changes to the o1-02 monitor requires a drive power-up cycle to be effective.
YASKAWA TM.iQp.10 iQpump Technical Manual Supplement
Description
8 Geothermal Mode
iQpump Controller
5
0
20
1
2
80
0
0.0 °F
120.0 °F
35.00 Hz
60.00 Hz
55.0 °F
65.0 °F
75.0 °F
85.0 °F
1
25
Advertisement
Table of Contents
