YASKAWA iQpump Manual Supplement page 19

Multi-function Output Setting H2-
Setting
This output will energize if P8-01 = 2 and the suction pressure drops below the Low Suction Pressure
58 Low Suction Detection Level (P8-07) for more than the Low Suction Pressure Delay Time (P8-08), or if there is a
LOSUC - Low Suction Pressure Fault.
Related Parameters
When P1-01 = 3 (Memobus Multiplex), the Water Level or Suction Pressure can be transmitted or read through the
network. Refer to Water Level/Suction Pressure Control in Memobus Multiplex on page
P9-50 Water Level Source (P8-01 set to 0 or 1, Water Level Control)
Defines which signal to use for Water Level Control (P8-
Setting has no effect when P1-01≠3.
Setting
0 Analog Only (factory default)
1 Analog -> Network, No Alarm
2 Analog -> Network, Alarm
3 Network Only
P9-50 Suction Pressure Level Source (P8-01 set to 2 Suction Control)
Defines which signal to use for Suction Pressure Control (P8-
Setting has no effect when P1-01≠3.
Setting
0 Analog Only (factory default)
1 Analog -> Network, No Alarm
2 Analog -> Network, Alarm
3 Network Only
YASKAWA TM.iQp.10 iQpump Technical Manual Supplement
7 Suction Control via Constant Pressure w/Well Draw Down
: Low Suction (New)
) when P1-01=3.
Description
Description
) when P1-01=3.
Description
26.
19