Table of Contents
Advertisement
ENGLISH
14. Anti-tip tubes
14.1 Inserting anti-tippers in Receiver
Press the rear anti-tipper release pin
A on the anti-tipper tube so that
both release pins are drawn inside.
Insert into the anti-tipper receiver.
Slide the anti-tipper until release
pin is positioned through the lower
receiver mounting hole. Repeat the
process with the second anti-tip
tube.
14.2 Adjusting anti-tippers
Once the anti-tipper is installed, you must adjust its height to the proper
setting. To do so, press anti-tipper release pin B and raise or lower the moving
part of the anti-tipper.
Make sure the anti-tippers are fully engaged and release buttons fully
protruding out of adjustment holes. Anti-tippers must always be use.
When outdoors on wet, soft ground or on gravel surfaces, anti tippers
may not provide the same level of protection against tipover.
Always verify if the anti-tippers are at proper height after making any
adjustment or modification to the wheelchair in order to ensure the safety
of the user.
Physipro recommends anti-tippers for all wheelchairs. The anti-tippers are
not to be used as tipping levers.
Figure 58: Remove and adjust the anti-tip
40
NEOX™ Tilt-in-Space
Advertisement
Table of Contents
