Rear Wheels; Rear Wheel Setup And Height Adjustment; To Uninstall The Rear Wheel - Physipro NeoX Owner's Manual

Owners manual

6. Rear wheels

6.1 Rear Wheel installation and height adjustment
The wheels available for the NEOX™ are from 12" to 24" and 6 positions are
possible for the height.
Follow these steps to install the rear wheel:
1. Insert the positioning device B in the hole corresponding to the desired
height (Figure 12);
Slide axle A inside the positioning device B;
2.
Insert nut C at the end of the axle A;
3.
Tighten nut C with a ¾" wrench while holding the axle A with a ¾" ratchet.
4.
Note – To simplify this process; place the NEOX™ on a flat surface such as a table or a
bench.

6.2 To Uninstall the rear wheel

Loosen nut C with a ¾" wrench while holding the axle A with a ¾" ratchet;
1.
Remove nut C at the end of the axle A;
2.
Slide axle A outside the positioning device B;
3.
Remove axle A from the wheel.
4.
Always check the steadiness of the wheelchair. It may require a
modification of the seat or the mid wheel positioning device.
Figure 12 : Rear Wheel Installation
15
ENGLISH
Revision 5
January 2016