ITech IT6000B Series User Manual page 154

•
Select Curve file
You can select the Curve file saved in the instrument to be in the Open state for
later running.
1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-
2. Use knob or Up/Down key to select 4. SAS: Off and press [Enter].
3. Press the Left/Right key to select Static and press [Enter].
4. Press the Left/Right key to select Curve and press [Enter].
5. Press the Left/Right key to select Open and press [Enter].
6. Set the name of the Curve file to be recalled (i.e. the file name set in Edit)
Run the Static PV Curve
•
– After the above Curve parameters are set completely, you can press
[Esc] until you return to the SAS main interface and select Run to
trigger the current edited Curve file to run.
User-defined
The steps to edit a custom curve are as follows:
1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to
enter the function menu.
2. Use knob or Up/Down key to select 4. SAS: Off and press [Enter].
3. Press the Left/Right key to select Static and press [Enter].
4. Press the Left/Right key to select User-defined and press [Enter].
5. Set the Voc, Imp and the other parameters, and press [Enter].
After the setting is completed, the system returns to the main interface of
the SAS function, and the currently edited custom curve is to be run. The
interface is displayed as follows:
FUNCTION SAS
Run Vmax Static
ter the function menu.
and press [Enter].
At this point, the system returns to the main interface of the SAS function,
and the currently selected Curve file is to be run. The interface is displayed
as follows:
FUNCTION SAS
Run Vmax Static
Curve
1. Refer to Select Curve file
Copyright © Itech Electronic Co., Ltd.
Table Filter
Table Filter
to select the Curve file to be run.
Power Supply Function
142