Table of Contents
Advertisement
•
Standards for 12V system:
Curve should be selected based on actual test requirements. To create
waveform within 12V, follow the set standards as below:
I, II, III, and IV defined in the above standard correspond to levels 1, 2, 3,
and 4 in the setup menu.
•
Standards for 24V system:
How to recall this waveform from menu (take 12V system as an example):
Copyright © Itech Electronic Co., Ltd.
Power Supply Function
91
Advertisement
Table of Contents
Need help?
Do you have a question about the IT6000B Series and is the answer not in the manual?