Fast Commissioning Steps At A Glance - Leuze electronic BPS 34 Operating Instructions Manual

Fast commissioning steps at a glance

3 Fast commissioning steps at a glance
Note!
Below you will find a short description for the initial commissioning of the bar code posi-
tioning system BPS 34. Detailed explanations of all listed points can be found throughout
the handbook.
Description of the BPS 34 functions
The BPS 34 uses visible red laser light to determine its position relative to the bar code tape.
This essentially takes place in three steps:
1. Reading a code on the bar code tape
2. Determining the position of the read code in the scanning area of the scanning beam
3. Calculating the position to within a millimeter using the code information and the code
position relative to the device's center.
The position value is then output via the interface.
Œ
Mechanical design
Mounting the bar code tape
The bar code tape is to be affixed without tension to a dust- and grease-free mounting
surface.
Chapter 6.3 on Page 30
Mounting the BPS 34 device
There are 2 different types of mounting arrangements for the BPS 34:
1. Using 4 M4x6 screws on the rear of the device.
2. Using a mounting device (BT 56) on the dovetail fastening grooves.
8 BPS 34 Leuze electronic