Leuze electronic BPS 34 Operating Instructions Manual page 51

Device parameters and interfaces
Module
Page
M22
Page 82
M23
Page 84
M24
Page 86
Static speed limit values
M25
Page 87
M26
Page 89
M27
Page 91
Table 8.1:
50
Module name
Speed
measurement
control
Speed
measurement
status
Min./max.
speed
(for limit value 1 ... 4)
Dynamic
speed
limit values
Tape value correction
Overview of the GSD modules
Module contents
(P) = Parameter, (O) = Output, (I) = Input
(P) Speed measurement start mode
(P) Speed measurement stop mode
(I) Speed measurement state
(O) Start event
(O) Stop event
(O) Min./max. speed mode
(O) Min./max. speed reset
(I) Measurement error
(I) Limit value status 1 exceeded
(I) Limit value status 2 exceeded
(I) Limit value status 3 exceeded
(I) Limit value status 4 exceeded
(I) Dynamic limit value status exceeded
(I) Movement status
(I) Direction of movement
(I) Compare limit value state 1
(I) Compare limit value state 2
(I) Compare limit value state 3
(I) Compare limit value state 4
(I) Compare dynamic limit value state
(I) Minimum speed
(I) Maximum speed
(P) Speed limit value mode (active/not active)
(P) Direction selection (both directions or only one)
(P) Switching type (value is above or below the
defined limits)
(P) Speed limit value
(P) Hysteresis
(P) Range start
(P) Range end
(O) Limit value control
(O) Switching type (value is above or below the
defined limits)
(O) Direction selection
(O) Limit value
(O) Hysteresis
(O) Range start
(O) Range end
(P) Real length
(P) Range start
(P) Range end
BPS 34 Leuze electronic