7.3.1.1 Edit Zone Name
7. Press
to edit the selected zone's name.
1
A screen similar to the one shown in Figure 7-2 displays.
8. Select the characters for the zone name by pressing the
character is shown then press
OR
Enter the Numerical Designator for the character you want, then press
a list of available characters and their numeric designators.
9. Repeat step 8 until the name is complete.
10. Press
when the name is complete.
7.3.1.2 Edit Zone Properties
Zone properties consist of alarm delay characteristics, and heat detector sensitivity.
1. Do steps 1 through 6 of Section 7.3.1.
2. Press
to edit the properties of the selected zone.
2
151209
Figure 7-2 Selecting Character for Zone Name
.
Detection type also selected from this screen
firealarmresources.com
Programming
or
arrow until the desired
. See Appendix B for
(see Table 7-1).
7-5