Programming Overview; Jumpstart Autoprogramming - Honeywell Silent Knight IntelliKnight 5820XL Installation And Operation Manual

Section 6

Programming Overview

This section of the manual is intended to give you an overview of the programming process.
Please read this section of the manual carefully, especially if you are programming the control
panel for the first time.
The JumpStart feature automates many programming tasks and selects default options for the
system. You will run JumpStart at least once when you are installing the system. See Section
6.1 for details. After you run JumpStart, you may need to do some additional programming
depending on your installation. Section 7 of this manual covers manual programmable options
in detail.
Programming the panel can be thought of as a three part process. You must program:
• System options. These are options that affect general operation of the panel (see Section
7.6 for details).
• Options for input points and zones. These are primarily options that control detection
behavior of devices (see Section 7.5 for details).
• Options for output points and groups. This includes selecting characteristics for output
groups and mapping output circuits to output groups (see Section 7.5 for details).
6.1

JumpStart Autoprogramming

The JumpStart feature allows for faster system setup. When you run JumpStart (immediately
after addressing SLC devices), the system scans devices on all SLC loops and determines
device type (for example, ionization smoke detector or heat sensor) and selects some system
options based on the device type. This saves the installer from having to program options for
each device. Depending on the application, the installer may need to make some changes after
JumpStart completes.
See Section 6.1.3 for complete details about running JumpStart.
JumpStart is intended to be run one time only, immediately after SLC devices have been addressed and connected.
JumpStart will reset all manually programmed options to default settings. Do not run JumpStart after you have
configured the system.
151209
IMPORTANT
firealarmresources.com
6-1