Table of Contents
Advertisement
IntelliKnight 5820XL Installation Manual
7.4
Group
An output group is made up of output points that have been programmed to respond in the
same way. Output groups simplify programming because you have to program the output
characteristics that are common to all of the group points once, instead of programming each
individual point. Once you have defined the characteristics of output groups, you can assign
each point to the appropriate group. All valid output points are assigned to only one output
group. Unused points are not assigned to any output group. Up to 250 output groups can be
defined.
7.4.1
Edit Group
In the edit group option you can program the name of an output group (Section 7.4.1.1) and
change the properties (Section 7.4.1.2) of that group.
To edit a group, follow these steps:
1. Enter the installer code.
2. Press
to display the main menu.
or
3. Select
for Program Menu.
7
Display reads:
4. Press
to enter group menu.
3
5. Press
to edit group.
1
6. Enter the number of the group you wish to edit, then press
7.4.1.1 Edit Group Name
7. To edit the group name, press
A screen similar to the one shown in Figure 7-2 displays.
7-14
Initializing
Please wait . . .
.
1
Figure 7-7 Selecting Character for Zone Name
firealarmresources.com
.
151209
Advertisement
Table of Contents
Troubleshooting
