Modem Configuration And Profile; Modem Register Commands; Table 84. Effects Of Parameter Settings - Motorola g20 Developer's Manual

OK
(Voice and data international calls barred, fax not barred.)
AT+CLCK="OI",2
+CLCK: 1,1
+CLCK: 1,2
+CLCK: 0,4
OK
4.10

MODEM CONFIGURATION AND PROFILE

4.10.1

Modem Register Commands

The g20 holds certain data items in selected memory space, named Software Registers (S-registers) and Modem Registers. Some
of these registers are used as bitmaps, where one register holds more than one data item.
All S-registers can be accessed using the S command, described in "S, Bit Map Registers" on page 186. Some registers can also
be accessed using dedicated commands, detailed below.
4.10.1.1 V, DCE Response Format
This command determines the response format of the data adapter and the contents of the header and trailer transmitted with the
result codes and information responses. This command also determines whether the result codes are transmitted in a numeric or
an alphabetic ("verbose") form. The text portion of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information text and result codes.
Information Responses
Result Codes
Set Command
The Set command sets the format of information responses and result codes.
Command
ATV<value>
98-08901C68-O

Table 84. Effects of Parameter Settings

V0
<text><cr><lf>
<numeric code><cr>
OK
or:
+CMS ERROR: <err>
<cr><lf><text><cr><lf>
<cr><lf><verbose code><cr><lf>
Response/Action
AT Commands Reference
V1
181