Table of Contents
Advertisement
Using the Commands
05E7?
05DC?
000Dcarriage return
000Aline feed
UCS2 coding for ASCII characters (A-Z, 0-9, and so on) is the same as for their ASCII coding, padded with zeros
to make it 16-bits wide.
UCS2 coding for Hebrew characters is from 05D0 (?) to 05EA (?).
Note
5.7
SLEEP MODE
The notation of TXD and RXD are from the perspective of the terminal unless otherwise specified.
Note
The terminal should activate Sleep mode by sending ATS24=n (n - number of seconds). To disable Sleep mode, send ATS24=0.
Example of g20 Entering Sleep Mode
Terminal-TX: ATS24=n
Terminal-TX: ATxxx
Terminal-Wakeup-In=Inactive
g20-CTS=Inactive
Example of Terminal Wake g20 Sleep Mode
Terminal-Wakeup-In=Active
g20-CTS=Active
Terminal-TX: ATxxx
Example of g20 Wake Terminal Up
g20-CTS=Active
g20-Wakeup-Out=Active
g20-TX: RING
278
//n seconds passed since last command (and other conditions met)
//g20 enters Sleep mode
//g20 exits Sleep mode
//30 mseconds passed since Terminal-Wakeup-In became active
//g20 internal event occurred. Incoming call is pending
//g20 exits Sleep mode
//T mseconds passed since Terminal-Wakeup-Out became active
(T is defined by ATS102.)
98-08901C68-O
Advertisement
Table of Contents
