Table 90. &F Parameters - Motorola g20 Developer's Manual

4.10.1.8 &F, Set to Factory Defined Configuration
This command restores the factory default configuration profile. The g20 only supports one factory default profile, 0.
Set Command
Command
AT&F<value>
Read Command.
Command
AT&F?
Test Command
The Test command for &F is not defined by ITU, and therefore is not supported by the g20. The g20 returns an error.
The following table shows the &F parameters.
<Parameter>
<value> 0
Example
AT&F?
000
OK
AT&F0
OK
98-08901C68-O
OK
or:
+CMS ERROR: <err>
F: <current profile number>
Table 90. &F Parameters
Description
Factory default configuration profile. This is the only
value supported.
Response/Action
Response/Action
AT Commands Reference
189