AT Commands Reference
Test Command
The Test command returns <n> values supported by the g20.
Command
+CLIR=?
The following table shows the +CLIR parameters.
<Parameter>
<n>
Adjustment for outgoing calls
0
1
2
The default is 0.
Note: When <n> is set to 0, the g20 treats CLIR as enabled
if the <m> value is 1 or 3. If the <m> value is 0, 4 or 2, the
g20 treats CLIR as disabled.
<m>
Subscriber CLIR service status in the network
0
1
2
3
4
Example
at+clir=?
+CLIR: (0,1,2)
OK
at+clir?
+CLIR: 1,4
at+clir=2
OK
atd054565195;
OK
(... calling ...)
76
+CLIR: (0,1,2)
Table 24. +CLIR Parameters
Description
Presentation indicator is used according to the
subscription of the CLIR service in the network.
Enable (CLIR On = CLI Restricted)
Disable (CLIR Off = CLI Presented)
CLIR not provisioned
CLIR provisioned in permanent mode
Unknown (for example, no network and so on)
CLIR Temporary mode presentation restricted (can be
the default)
CLIR Temporary mode presentation allowed (can be
the default)
//g20 setting - enable CLIR, network provision is - Temporary mode presentation
allowed
//MO voice call
Response/Action
98-08901C68-O