Read Command
Command
+MIPPUSH?
Test Command
Command
+MIPPUSH=?
The following table shows the +MIPPUSH parameters.
Table 133. +MIPPUSH Parameters
<Parameter>
Socket ID
1,2,3,4 Number of valid socket
Extended err
3
Example
at+MIPPUSH=1
+MIPPUSH: 0
OK
4.15.2.7
+MIPFLUSH, Flush Data from Buffers
This command causes the g20 to flush (delete) data accumulated in its accumulating buffers.
Set Command
Command
+MIPFLUSH = <Socket ID>
98-08901C68-O
MIPPUSH:<socket ID>,<CR><LF>
For all ACTIVE sockets.
MIPPUSH=(1-4)
Description
Operation not allowed
//Terminal asks the g20 to flush the buffer in socket 1 (was opened using the
+MIPOPEN command)
ERROR
or:
+MIPFLUSH: <Socket ID>
OK
Response/Action
Response/Action
Response/Action
AT Commands Reference
255