Table 64. +Cbc Parameters - Motorola g20 Developer's Manual

AT Commands Reference
The following table shows the +CBC parameters.
<Parameter>
<bcs> Battery status values
0
1
2
3
Note: The g20 input power source is connected via the
battery pins.
<bcl> Battery Charge level
0
1-100 Indicates percentage of charge remaining
The g20 does not allow the detection of battery use. The power supply of the g20 is connected via the battery pins.
However, users can use this command to verify the level of the g20 input power source.
Note
Example
at+cbc
+CBC: 0,60
OK
4.7.1.2 +CBAUD, Baud Rate Regulation
This command sets the request baud rate. The baud rate of the g20 is changed/set to the request value <rate> written in the
command.
Specifying a value of 9 disables the function and allows operation only at rates automatically detectable by the g20. The
specified rate takes effect following the issuing of any result code(s) associated with the current command line.
The UART is configured according to the request, or to the specific constant baud rate or auto baud rate after output "OK"
response to the terminal. For example, AT+CBAUD=8 is equivalent to AT+CBAUD=57600. Using AT+CBAUD with the
<rate> value other than 9 disables the auto baud rate detection feature. The g20 supports up to 115200 auto baud.
Set Command
Command
AT+CBAUD=<n>
AT+CBAUD=<rate>
146

Table 64. +CBC Parameters

Description
Battery powered
Externally powered, battery connected
Externally powered, no battery connected
Invalid power supply
Indicates no battery
//This example shows 0 (battery powered) with 60% power.
OK
or:
ERROR
Response/Action
98-08901C68-O