Table of Contents
Advertisement
AT Commands Reference
4.3.3.2
D>, Direct Dialing from Phone Books
This command places a FAX/DATA/VOICE call on the current network by dialing directly from the g20 phone book.
Command
ATD><number>[;]
+CME ERROR: NOT FOUND is returned when no match is found in an existing phone book.
Note
The following table shows a detailed description for the D> commands.
Command
D><alpha>[;]
D>mem<n>[;]
D><n>[;]
54
Response/Action
VOICE CALL:
1st response - Voice call place begins
OK
2nd response - Voice call connected:
CONNECT
DATA/FAX:
2nd response only - Data/Fax call connected
CONNECT
When MO call fails:
1. Connection Failure - NO CARRIER or BUSY or NO
ANSWER
2. General Failure - ERROR
Table 14. D> Commands
Detailed Description
Originates a call to a phone number with the
corresponding alphanumeric field <alpha>. The
currently used memory (phone book) is searched for
the entry that begins with the alphanumeric pattern
<alpha>.
Originates a call to a phone number in memory (phone
book) mem and stored in entry location <n>. Available
memories may be queried with Select Phone Book
Storage Test command +CPBS=?, described on page
94.
Note: This command does not change the used
memory set.
Originates a call to a phone number from entry
location <n> in the currently used memory.
98-08901C68-O
Advertisement
Table of Contents
