Using the Commands
From this point on, the terminal is not allowed to send data until it receives the +MIPXON command.
+MIPSEND=1,A344343ABC343438980BC...AB4 //Terminal disregards the Xoff request of g20 and keeps sending
ERROR 3
+MIPXON: 1
5.9.4
Error in Reopening a Valid Socket
at+mipcall=1,"orange","test","test"
OK
+MIPCALL:123.345.567.890
+MIPOPEN=1,1222,"123.343.444.332",1234,0
OK
+MIPOPEN:1,1
+MIPOPEN?
+MIPOPEN: 2 3 4
MIPOPEN=1,12,123.343.444.332,234,0
ERROR
5.10
AUDIO
5.10.1
Scenarios for Setting Up Handset Mode or Handsfree Mode
5.10.1.1
Handset Mode
AT+MAPATH=1,1
AT+MAPATH=2,1,3
AT+MAPATH=2,3,12
AT+MAFEAT=6,0
AT+MAFEAT=1,1
286
//(Note: The terminal does not stop.)
//g20 pushed the data into the protocol stack and is able to handle more
sends from the terminal
//Opening socket 1 using TCP protocol, from port 1222,
targeting 123.343.444.332 port 1234
//Terminal checking the status of socket to be ready
//Terminal tries to reopen socket 1
//Set the input path through the microphone
//Set voice and keypad through the earpiece speaker
//Set alerts and rings to go through the transducer
//Disable echo cancellation and noise suppression
//Enable sidetone
98-08901C68-O