Table of Contents
Advertisement
WAKEUP-OUT
g20 TXD
4.10.2.3
S24, Set Number of Seconds Delay Before g20 Enters Sleep Mode
This command activates/disables the Sleep mode. The terminal sends ATS24=5, and if there are no radio and UART activities,
the g20 enters sleep mode in 5 seconds.
If terminal has some indication of the CTS pin activity, it can see:
• If +MSCTS=0 (default), the line changes its state periodically. (For more information refer to "+MSCTS, Enable/Disable
CTS During Wakeup Period" on page 195.)
• If +MSCTS=1, the line is switched off at the moment of entering Sleep mode and stays off even if g20 is awakened.
Set Command
The Set command sets the amount of time, in seconds, the g20 should wait before entering Sleep mode.
Command
ATS24=[<value>]
Read Command
The Read command returns the current value.
Command
ATS24?
The following table shows the S24 parameters.
<Parameter>
<value>
Number of seconds (0 <= n <= 255)
0
>0 Enable Sleep mode
The default value is 0.
98-08901C68-O
S102
Figure 15. g20 Lines when S24 > 0
OK
<value>
OK
Table 92. S24 Parameters
Description
Disable Sleep mode
S102
Response/Action
Response/Action
AT Commands Reference
193
Advertisement
Table of Contents
