FLIR Ariel CM-3102 User And Installation Manual page 74

December 12, 2018
1.800.561.8187
ii.
If you select MJPEG, the following fields are displayed:
a. From the Quality Level drop-down list, select High, Mid, or Low. The default is Mid.
Low produces the highest image quality, but increases the file size. High produces
the lowest image quality, but decreases the file size.
In the DSCP text box, enter a value between 0-63. The default DSCP value is 0
(DSCP disabled).
The DSCP (Differentiated Services Code Point) value defines the priority level or QoS
(Quality of Service) for the specified type of traffic. The higher the value that is entered,
the higher the priority, which reduces network delay and congestion. The camera
supports the Video DSCP class, which consists of applications such as HTTP,
RTP/RTSP, and RTSP/HTTP.
Note:
Remember to synchronize the QoS setting of the camera with the network router.
Move the Frame Rate slider to a value between 1-30 for NTSC or 1-25 for PAL systems.
The maximum frame is displayed by default. The higher the FPS, the smoother the
motion in the video.
The Rate Control is pre-configured and cannot be changed.
Note:
The Rate Control setting is displayed only when H.264 is selected.
Set the Max Bit Rate to a value between 64 to 20000. The default settings are 3110
kbps for 1080p, 1382 kbps for 720p, and 750 kbps for D1. The higher the bit rate, the
better the image quality. Set the maximum bit rate high enough to allow for a high
instantaneous bit for more complex video. A higher bit rate consumes more storage
space.
Note:
The Max Bit Rate setting is displayed only when H.264 is selected.
Set the Encoding Priority. This function enables the user to adjust the quality of the
picture along a single axis. The slider ranges from 1 (low bit rate) to 10 (high picture
quality). The default setting is 7.
The slider is configured based on Quantization Parameter (QP) values. Setting QP to a
high value increases the bit rate and results in high compression, but this is at the
expense of poor decoded image quality. Setting QP to a low value results in better
decoded image quality, but with lower compression.
Ariel CM-3102 User and Installation Guide
www.
Accessing the CM-3102 via a Web Browser
information@itm.com
.com
75