FLIR C2 Instructions

Hide thumbs Also See for C2:

Brown County Beekeepers

FLUR Cx Infrared Camera instructions

Note: includes case, camera, USB and wall plug

Important CARE INSTRUCTIONS:

NOTE: You will be responsible for damage to the Infrared camera, please read instructions carefully.

Do not point the camera at the sun – this can cause damage to the detector/sensors

Do not allow camera to sit in a hot car – this can damage camera sensors

Be careful when cleaning lenses – always use lens paper or cloth. Lens can be easily damaged.

Be sure to wipe any water / snow off of the camera after use

Front

Back

1. Charging the Camera

– plug FLUR power connector into wall outlet, plug USB into FLUR camera

Table of Contents

Do you have a question about the C2 and is the answer not in the manual?

Page 1 Brown County Beekeepers FLUR Cx Infrared Camera instructions Note: includes case, camera, USB and wall plug Important CARE INSTRUCTIONS: NOTE: You will be responsible for damage to the Infrared camera, please read instructions carefully. Do not point the camera at the sun – this can cause damage to the detector/sensors Do not allow camera to sit in a hot car –...
Page 2 2. Turn on the Camera by pressing ON button Loading bar It will take a minute for the camera to load. 3. Saving an IMAGE - point camera at your hive and when ready press SAVE button (taking the picture). The camera will save both thermal and visual picture.
Page 3 4. Recalling/deleting your images – tap on the camera screen and the “tool bar” will come up. Select IMAGE Tool Bar allows you to: a. Recall/review pictures you’ve just taken b. Removes center spot if you don’t want it there c.