Table of Contents
Advertisement
Accessing the CM-3102 via a Web Browser
To configure quality settings
To configure color settings
To configure mirror flip settings
The White Balance screen is used to create the best color rendition.
To set the White Balance mode
92
1.800.561.8187
In the Quality section, configure the following settings:
Sharpness
Set the slider between 0-100, which provides the highest
sharpness around the edges and for small features. The default setting is 40.
3D Noise Reduction
Gamma Correction
setting is 0.45. Gamma correction is used to ensure faithful reproduction of
an image. When gamma = 1, the original image is the same as the image
displayed on your screen. If the gamma is set at 0.45, there will be less
contrast.
In the Color section, configure the following settings:
Brightness
Set the image brightness between -100 to 100, which provides
the highest brightness. The default is 0.
Contrast
Set the image contrast between -100 to 100, which provides the
highest contrast. The default is 0.
Saturation
Set the image saturation -100 to 100. The lower the number, the
closer the image is to a grayscale (i.e., monochrome or black-and-white)
image. The higher the number, the deeper the color image (i.e., reds will be
redder and blues will be bluer). The default is 0.
Hue
Set the image hue between -100 to 100, which provides the deepest
hue. The default is 0.
In the Mirror Flip Setting section, from the Orientation drop-down list, select one of the following:
Flip
This setting flips the image upside-down.
Mirror
This setting views the image from a different angle.
Both
This setting views the image upside-down from a different angle.
OFF (default)
White Balance
From the Mode drop-down list, select one of the following options:
ATW
In ATW mode, color is continuously adjusted according to the color
temperature of the scene illumination. This is the default setting.
Ariel CM-3102 User and Installation Guide
www.
Set the slider between 0-100. The default setting is 20.
From the drop-down list, select 0.45 or 1. The default
.com
December 12, 2018
information@itm.com
Advertisement
Table of Contents
