Table of Contents
Advertisement
To configure IP settings
December 12, 2018
1.800.561.8187
Click View to view current network settings. The Internet Explorer Basic Settings dialog box
opens, displaying network interface information, including Ethernet connection speed, Ethernet
NIC MAC address, unit IP address, multicast address, and subnet mask. In the case of an IPv6
connection, the IPv6 address and IPv6 DNS address also are displayed.
In the IP Settings section, configure the following settings
Mode
From the drop-down list, select one of the following:
Manual
Used for connecting to the network via a static IP address.
PPPoE
The camera can access the network via a DSL modem using the
Point-to-Point Protocol over Ethernet (PPPoE). When connecting via a
PPPoE connection, the IP Address field is disabled. After selecting this
mode, enter the User Name and Password for the PPPoE account.
DHCP
Used for connecting to the network via a DHCP server. In DHCP
mode, the IPv4 Address, IPv4 Subnet Mask, and IPv4 Default Gateway
fields are disabled.
IPv4 Address
The IP address is necessary for network identification. Enter the IPv4
address if you are using IPv4 to connect to the network in Manual mode. In PPPoE and
DHCP modes, the IPv4 address is assigned automatically.
IPv4 Subnet Mask
default value is 255.255.255.0. Enter the IPv4 subnet mask address if you are using
IPv4 to connect to the network in Manual mode. In PPPoE and DHCP modes, the IPv4
subnet mask address is assigned automatically.
IPv4 Default Gateway
invalid gateway setting causes transmission to destinations in other subnets to fail. Enter
the IPv4 default gateway address if you are using IPv4 to connect to the network in
Manual mode. In PPPoE and DHCP modes, the IPv4 default gateway address is
assigned automatically.
IPv6 Enable
If you are using IPv6, select the checkbox to enable IPv6.
Accept IPv6 Router Advertisement
OFF.
Enable DHCPv6
If you are using IPv6, select ON. The default is OFF.
IPv6 Address
If you are using IPv6, enter the IPv6 address.
Subnet Prefix Length
digits).
Ariel CM-3102 User and Installation Guide
www.
Used to determine if the destination is in the same subnet. The
Used to forward frames to destinations in a different subnet. An
If you are using IPv6, select ON. The default is
If you are using IPv6, enter the subnet prefix length (1-128
.com
Accessing the CM-3102 via a Web Browser
information@itm.com
49
Advertisement
Table of Contents
