FLIR Ariel CM-3102 User And Installation Manual page 64

6.3.1.5.4
The Events Source > Motion screen is used for defining the motion zone area settings; defining
settings, including the method for storing a snapshot, recording on the edge, email headers, and text for
the OSD; and for setting the arming schedule.
Note:
If the camera is attached to Latitude, motion detection configuration should be done from Latitude
Admin Center, not from the web interface.
To enable motion settings
To configure motion zone area settings
To define the method to store a snapshot
To record the event on the camera
To enable sending an email notification
To define OSD text
December 12, 2018
1.800.561.8187
Motion
Click Enable. By default, Enable is not checked.
Click Save Area.
From the Sensitivity drop-down list, select High, Medium, or Low. The camera reacts to slight
changes in motion or brightness in the motion zone when set to High, while the camera reacts to
big changes in brightness or motion when set to Low.
See instructions in section 6.3.1.5.1.
See instructions in section 6.3.1.5.1
See instructions in section 6.3.1.5.1.
See instructions in section 6.3.1.5.1.
Ariel CM-3102 User and Installation Guide
www.
Accessing the CM-3102 via a Web Browser
information@itm.com
.com
65