Network Proxy Configuration - ZyXEL Communications XMG1930 Series User Manual

Table 31 Basic Setting > IP Setup > IP Configuration (continued)
LABEL
DHCP Client
Static IP
Address
IP Address
IP Subnet
Mask
VID
Add
Cancel
Index
IP Address
IP Subnet Mask
VID
Type
Delete
Cancel

8.5.5 Network Proxy Configuration

The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center)
Switch and NCC through the proxy server.
Figure 66 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Chapter 8 Basic Setting
DESCRIPTION
Select this option if you have a DHCP server that can assign the Switch an IP address, subnet
mask, a default gateway IP address and a domain name server IP address automatically.
Select this option if you do not have a DHCP server or if you wish to assign static IP address
information to the Switch. You need to fill in the following fields when you select this option.
Enter the IP address of your Switch in dotted decimal notation, for example, 192.168.1.1. This is
the IP address of the Switch in an IP routing domain.
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.255.0.
Enter the VLAN identification number to which an IP routing domain belongs.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This field displays the index number of an entry.
This field displays the IP address of the Switch in the IP domain.
This field displays the subnet mask of the Switch in the IP domain.
This field displays the VLAN identification number of the IP domain on the Switch.
This field displays the type of IP address status.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Click Cancel to clear the check boxes.
(Section 8.10 on page 121). Use this screen to enable communication between the
XMG1930 Series User's Guide
98