Network Proxy Configuration - ZyXEL Communications GS1920v2 Series User Manual

Figure 79 SYSTEM > IP Setup > IP Setup > Add/Edit
The following table describes the labels in this screen.
Table 35 SYSTEM > IP Setup > IP Setup > Add/Edit
LABEL
IP Address
IP Subnet Mask
Default
Gateway
VID
Apply
Clear
Cancel

21.4 Network Proxy Configuration

The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center) (See
Switch and NCC through the proxy server.
Figure 80 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Chapter 21 IP Setup
DESCRIPTION
Enter the IP address of your Switch in dotted decimal notation, for example, 172.21.40.x. This is
the IP address of the Switch in an IP routing domain.
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.252.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation, for example
172.21.43.254.
Enter the VLAN identification number to which an IP routing domain belongs.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to reset the fields to your previous configuration.
Section 18.1 on page
GS1920v2 Series User's Guide
111). Use this screen to enable communication between the
124